Operating instructions

ULTRA XP OPERATING INSTRUCTIONS

2. Insert the five exposed conductors into the five cable holes in a Phoenix 5-pin female cable mount connector. Use the

following wiring scheme.

3. Secure the conductors by tightening the five screws in the Phoenix cable mount connector. Screws should be torqued to

5–6 Nm(4.4–5.3 In-Lbs).

CAUTION: Screws should not be inserted into the Phoenix connector while the connector rests in a mating

plug. Doing so will damage the contacts. During assembly, the Phoenix connector should only be held in place

externally.

4. If the other (EN3) end of the cable has not been stripped, strip the outer shielding 1 inch and then strip the black, red,

blue, and white wires 0.275 inch.

5. Disassemble the EN3 5-pin female connector and feed the stripped cable through the boot, cable clamp housing, and

coupling ring.

Pin Destinations for Phoenix 5-Pin Female Cable Mount Connector

EN3 5-Pin Female Cable Mount Connector, Assembled (Left), Disassembled (Right)

Pin 1 Black 48 V DC (–)

Pin 2 Red 48 V DC (+)

Pin 3 Shield drain Audio shield

Pin 4 Blue Audio (–)

Pin 5 White Audio (+)

Tighten screws

Cable clamp

housing

Boot

Coupling

ring

Cord

connector