Operating instructions

ULTRA XP OPERATING INSTRUCTIONS

To assemble an EN3-to-EN3 loudspeaker cable:

1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1 inch and then strip the

black, red, blue, and white wires by 0.275 inch.

2. Disassemble the EN3 5-pin male connector and feed the stripped cable through the boot, cable clamp housing, and

coupling ring.

3. Solder the five exposed conductors to the five pins on the EN3 cord connector using the following wiring scheme.

4. Reassemble the EN3 5-pin male connector:

■ Align the coupling ring’s side notches with the cord connector’s side notches and slide the couple ring onto the cord

connector.

■ Carefully insert the end of the cable clamp housing into the cord connector until it locks into place. Snap the cable

clamps in the cable clamp housing into their compartments.

■ Slide the boot forward so it covers the cable clamp housing completely.

Disassembled EN3 5-Pin Male Cable Mount Connector

Pin Destinations for EN3 5-Pin Male Cable Mount Connector

1”

0.275”

Cable clamp

housing

Boot

Coupling

ring

Cord

connector

Pin 5, White,

audio (+)

Pin 4, Blue,

audio (–)

Pin 2, Red,

48 V DC (+)

Pin 1, Black,

48 V DC (–)

Pin #3, Shield drain,

audio shield

Pin 5, White,

audio (+)

Pin 4, Blue,

audio (–)

REAR

FRONT

Dimple identifies Pin 1