Specifications
3
5
4
1
2
34
Place the back cushion
The back cushion (1) is to be folded
over in the centre between the two
horizontal seams 180° around the up-
per spanning straps (2), (3). – This cre-
ates a soft upper edge.
☞ Note:
When the user leans against the
front cushion again, pay attention
that:
☞ The pressure of the back must be
spread evenly throughout the back
cushion.
☞ A complete hand should fi t in be-
tween the cushion and back at the
upper edge of the back cushion.
☞ The head of the user must be held
at balance by the back cushion.
The extended parts of the back sup-
port are fastened to the top or bot-
tom seat surface depending on the
adjusted back support height (4).
☞ Note:
With an adjusted back support
height from 9 cm according to the
scale on the side, the straps of the
back cushion are led around the
back tubes (5).