Specifications

CD-3706/P Operator’s Guide
Document Revision: 030501.1
5500 Series Operator’s Guide
Document Revision:05/07/07
Page 28
ATIP Codes (CD-R/RW series only)
ATIP stands for “Absolute Time In Pre-Groove”. In firmware 1.0XX and higher,
the ATIP option allows you to determine the manufacturer of the disc placed in
the top drive of the 5500. It will also determine the minutes, seconds, and frames
present on the disc. Many generic brand CDs will not be recognized.
Reading ATIP Codes
To read an ATIP Code from a disc, the steps are as follows:
• From the main operating screen depicted below:
• Place the disc that you wish to read the ATIP information from, into the
top drive of the 5500.
• Click the “7” key. The screen will now read:
• Click the “STOP/NO” key. The screen will now read:
• Click the “STOP/NO” key. The screen will now read:
• Click the “STOP/NO” key. The screen will now read:
• Click the “START/YES” KEY. The screen will now read something
similar to this.
• The screen will now read something similar to the following: