Specifications

CD-3706/P Operator’s Guide
Document Revision: 030501.1
5500 Series Operator’s Guide
Document Revision:05/07/07
Page 33
Utilizing the 5500 Series Client
The 5500 series has a client feature which enables a remote user.
Configuring the 5500 Series
• Connect the 5500 Series to your network using the RJ-45 connector
on the back of the system.
• Turn on the 5500 Series
• Wait for the 5500 Series to boot up, you will see:
• Click the “7” key, you will see:
• Click the “START/YES” key, you will see:
• You must leave “MF” at the front of the name. You should name it
“MF001” for example.
• Click the “START/YES” key, you will see:
• Click the “Stop No” key if the network does not use DHCP or click
the “START/YES” key if the network does use DHCP. If you click
the ““START/YES” “ key you will be prompted to Restart the
system, if you click the “Stop No” key you will see:
• Enter the 4 sets of numbers of the IP address, one set at a time. After
each octet click the “START/YES” key. Do not enter an IP address
of a machine that is already on the network. When you have entered
in the entire IP address, you will see: