Specifications

CD-3706/P Operator’s Guide
Document Revision: 030501.1
5500 Series Operator’s Guide
Document Revision:05/07/07
Page 34
• Enter the 4 sets of numbers of the subnet. Clicking “START/YES”
after each set. You will then see:
• Click the “START/YES” key and then Restart the system by turning
it Off and back On again.
Configuring the Client
• Place the firmware CD into the CD-ROM drive of your PC
• Double click on “Embedded” folder
• Double click on SaClient.exe
• Click “Connect” in the lower right hand corner