Installation manual

Rev. 112205.1
Page 9
Making the connection
The Baxter requires a host PC to control it. Your PC should meet the
requirements detailed earlier. Installation is simple, and only a single USB
2 connection need be made between your PC and the Baxter.
• Make sure the Baxter power
switch is set to the off
position (0=Off, 1=ON).
• Connect one end of the
USB Cable to the USB port
on the back of the unit.
Connect the other to the
USB 2.0 port on the back of
your PC.
• Connect Power cable to the
power supply. Then connect the power cord from the power supply to
the wall outlet.
CAUTION
Always use properly grounded receptacles, or severe damage
to your system may result. The use of a surge protector or
Uninterruptible Power Supply (UPS) is highly recommended.
Starting Up / Driver Install
(Fig. 1)
• Insert the installation disc into your
computer disc drive.
• Once you have connected the USB
2.0 cable and the power, turn the
unit on by pressing rocker the to
“1” or “ON”. Your PC should now
prompt that it has “found new
hardware”: Click “install software
automatically” button (See Fig. 1).