Installation manual

Rev. 112205.1
Page 47
Relay mode job
Relay mode allows you to make multiple copies of multiple masters. Simply load the unit
with the desired number of blank discs, then the master such that the master sits on top of
the blanks. Then load in more blanks followed by the next master and so on. The end
result will be copies of each master placed in to the input bin(s).
1. Select the Relay-mode job button as seen in
(fig. 1).
2. Click Next.
3. Select the Operations and options for the
relay mode job.
4. Click Next.
5. If needed, you can move files up and down
in the list until the order of PRN files
matches the order in which your masters
were loaded (fig.4).
6. The Job parameters will then be displayed.
Give your job a name and select a priority.
7. Click Finish and the Scribe software will run
the job.
(fig. 1)
(fig. 2)