Installation manual

Rev. 112205.1
Page 49
Network Client Software
The Baxter comes the Scribe Network client. This allows you to connect the Baxter as
you would any Microsoft Windows XP PC on your network. In doing so, you can share
the Baxter with other users on your network allowing them to submit jobs remotely.
Client PC minimum requirements:
Client PCs should meet or exceed these minimum requirements:
• Pentium 4 or better processor
• 512 MB of RAM
• Windows XP or Windows 2000
• 10GB of free NTFS formatted hard disk space and meat the same.
• If you use firewall software, be sure not to block the port(s) used by the Baxter
client software (virtual port 12345)
• 100 Base-T network supporting Microsoft TCP/IP protocol.
Installing the client software
The Scribe network client, a file named ScribeClient.exe, was copied to your hard
drive during installation. The client software is a single .EXE file and simply needs to
be copied to the desired location You can do either by copying the file to a server, a
share on the PC you wish to give client privileges too, or use the Baxter and write the
file to disc.
Here we will show you how to install and run from the desktop of the Windows 2000
/ XP client PC.
• On your Baxter, right
click on
Start and select
Explore.
• Use Windows Explorer to
browse your Baxter’s hard
drive. If you have the
default factory
installation, locate the
"C:\Program Files\MF
Digital\Scribe\” folder.
• Right click on
Scribeclient.exe and select
COPY.