Installation manual

Rev. 112205.1
Page 7
Removing Packing Restraints
Be sure to remove all packing restraints before operation or power-on. Save
the foam block, as you will need to return it to its place when transporting
the unit in the future.
Setup
Before turning on your unit, please follow these steps:
Installing media adapters
The input media adapters allow you to set the input bin to accept standard
120mm discs, 80mm mini discs, or BizCDs.
Step 1: Install the four pillars on the Input bin
Note: The bottoms of the Pillars have 2 different
size posts, large and small. Place the pillars with
similar posts diagonally across from each other
into the corresponding holes.
Installing input bin
The input and output bins serve as the containers to store the blank and
recorded discs. The input bin attaches to the front of the unit and the output
is affixed to the top of the Baxter. Input / output capacity is 25 discs.
Rejects are discarded to the back left side of the unit.
Step 2: Attach the Input bin to Baxter
• Locate the input bin and place it on the
work surface.
• Lower the Baxter onto the input bin
such that the pins mate with the
matching recesses on the bottom of the
unit. Be sure nothing is under the input
bin and the unit and bin are sitting flat
and level.