Manual

Spectrum2 Printer Operator’s Guide

Document Revision: 100102

Printhead Replacement Procedure

Figure 16: The printhead's printing element is fragile, avoid touching the printing element

To replace printhead, you will need the following tools:

• Phillips-head screwdriver

Important: Always turn power off and unplug printer prior to removing print head.

Important: The printhead is fragile. Avoid touching the printing element and always

store the printhead on a soft area such as a clean paper towel

Wait until all printing has finished, and remove any CD still on the Tray.

• Power off and unplug printer

• Remove the top cover, remove ribbon, and set aside.

• Printhead is held by two Philips head screws

• Look down top of chassis to locate Philips head screws

• Use screw driver to loosen screw (note: screws are captive and will not fall out)

• Open Chassis (pull chassis knob out, and lift chassis)

• Printhead will hang from two cable connectors

• Note the position and orientation of the connectors

• Remove printhead from cable connectors, and place aside

• Attach cable connectors (noting orientation) to new printhead

Printing element

Print Control

Power Connection

Securing Screw

Holes