Owner Manual
Table Of Contents
- Introduction
- Table of Contents
- Safety Precautions
- Features and Specifications
- Stove Installation
- Planning the Installation
- Stove Placement Requirements
- Standard Installation
- Corner Installation
- Chimney Requirements
- Chimney Connector Requirements
- Chimney Termination Requirements
- Special Installation: Exterior Factory-Built Chimney
- Special Installation: Masonry Chimney
- Special Installation: Masonry Fireplace
- Installing the Soapstone
- Connecting the Combustion Fan
- Connecting the Smart Sensors
- Initial Curing
- How Catalyst Works
- Catalyst Smart App
- Regular Maintenance and Troubleshooting
- Monthly Maintenance
- Annual Maintenance
- Catalytic Combustor Replacement
- Lifetime Limited Warranty
23 | Page Catalyst Owner’s Manual | © MF Fire 2017
Connecting the Electronics
The combustion fan and smart controller are the two electronic
components that must be installed.
Special care should be taken when routing the primary power cord (the
right cord), and the combustion fan cord (the middle cord), and the
blower fan cord (the left cord). Under no circumstances should the
power cords be routed in front of or underneath the appliance. Be sure
to avoid contact with all metal on the stove, with the exception of the
blower duct, the rear-most piece of metal on the stove.
Combustion Fan
(AD-MF)
Smart Controller
Room Blower
(FB-MF)