User's Manual

To install the cordless Ni-MH handset battery pack:
1. Slide the battery pack up into the compartment at the
bottom of the handset. Make sure that the end of the
battery with the contacts is inserted first.
2. Snap the battery compartment cover into place.
3. Place the handset on the charging cradle.
4. Once you have installed the battery pack and placed
the handset on the cradle, you will hear a tone
Indicating the handset has connected with the charging
contacts and will successfully charge.
5. IMPORTANT : Charge the battery pack for at least 12
hours before using the handset the first time.
6. The IN USE/CHARGE LED on the charging cradle will
light when the handset is properly making contact with
the charge terminals.
Battery Duration
A fully charged battery lasts for approximately:
4 hours when you use the handset continuously (talk
time).
5 days when the handset is not in use (standby).
When the Battery Needs Char ging
The phone will beep.
The display will show the Low Battery icon.
When to Purchase a New Battery Pack
If the battery lasts only a few minutes even after a full charge, the usable life of the
battery has expired and needs to be replaced.
14
BATTERY INSTALLATION
BATT
AM
NEW TOTAL
1. To make a call from the phone book, press .
2. Use to locate the exact number you wish
to dial.
3. Press Tal k . The display will show the directory name,
and begin dialing the number.
4. When you are finished with your call, press Tal k, or
place the handset back on the base.
Making Calls From the Phone Book
1. Press .
2. Locate the number you wish to edit using or keys .
3. Press . The entry will display with a flashing
prompt over the first character.
4. Move the cursor to the section you wish to edit using
the , , , and keys. Characters or numbers will
be inserted in front of the cursor.
5. To erase a character or digit, press the key.
6. When the entry is edited as you desire, press and hold
to store the edited entry.
Editing a Stored Number
#
#
27
SPEED DIALING
Dir
Dir
Flash
RE/PA
Del / Scan