User's Manual

ManualsBrandsMGA Entertainment ManualsToys & GamesProject Mc2 H2O Powered RC Car

Table Of Contents

IMPORTANT INFORMATION

1. Using a Phillips screwdriver (not included) remove the

screw and battery compartment cover from the

underside of the engine inside the car.

2. Install six (6) fresh 1.5V AA alkaline batteries (not

included) in the engine making sure the (+)and (-) ends

face the proper direction as indicated inside the battery

compartment.

NOTE: Car batteries are layered with two batteries inserted on

the bottom layer and the four remaining batteries above it.

3. Replace the compartment cover and tighten the screw.

BATTERY INSTALLATION

Before playing, an adult must install fresh alkaline batteries in the CAR and REMOTE. Here’s how:

CAR ENGINE

REMOTE CONTROL

1. Using a Phillips screwdriver (not included) remove the

screw and battery compartment cover from the back

side of the remote.

2. Install two (2) fresh 1.5V AA alkaline batteries (not

included) making sure the (+) and (-) ends face the

proper direction as indicated inside the battery

compartment.

3. Replace the compartment cover and tighten the screw.

IMPORTANT NOTE:

In the event of a malfunction, reset the item by removing and replacing the batteries. If function is still not

restored, replace the batteries with fresh alkaline batteries.

QUICK START

QUICK START CONTINUED

NOTE: Before beginning, cover the play area to avoid possible water damage.

• Up to four cars can be used at the same time without interference. To use multiple cars at once, turn on one

remote and then one car. Then, repeat for the other cars. Only pair one remote and car at a time.

• If the lights do not blink when the car is on and the wires are connected to the correct ports on the engine,

add more water to the car’s tank.

• Always turn the car and the remote to the “OFF” position after playing to conserve battery power.

• Do not use the car in the street, anywhere there is vehicular traffic, or in heavily traveled pedestrian areas.

• Do not stand on, sit on or throw the car as doing so can result in injury to the person and irreversible

damage to the unit.

• Do not run the car into furniture, walls, pets, people etc., as doing so may cause injury to the people and pets

and irreparable damage to the unit.

• Keep long hair and loose apparel such as shoestrings away from the turning wheels of the car.

• Do not drive the car through water or mud.

• Do not leave water in the water can after use. Remove the cap, drain and air dry the water can before storing.

• Do not leave water in the car after use. Open the “gas” cap and turn the car sideways to empty all water. Air

dry thoroughly before storing.

Turn on the car by moving the

switch under the hood to “ON.”

Uncap the water can. Squeeze the can and

submerge it in water, then release to fill it up.

Open the “gas” cap on the car. Place the nozzle of

the water can into the opening and squeeze. Fill

the car with about four full cans of water. Then,

close the tank. The car headlights will blink.

The car headlights will stay illumiated and

light and steam will come from the tailpipes

as you drive the car.

Open the hood of the car. With the

engine in place, connect the wires to

the top of the engine. Red wire = plus

(+) port and black wire = minus (-) port.

Use the forward and reverse buttons on the

remote to drive your car.

The car fits two Project Mc2™ dolls (not included). Before driving make sure your dolls are belted in.

1. Remove the end of each belt from its slot in the center car console.

2. Place your doll comfortably in the seat.

3. Re-insert the end of the belt into the slot and press firmly.

Reverse and

hook left.

Forward

1.5V AA / LR6

Turn on the remote by moving the

switch on the controller to “ON.”