User Guide

ManualsBrandsMga Entertainment ManualsOtherALIEN RACERS SEA SKULL 1-4

SAFETY BATTERY USAGE

CAUTION

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the toy before being charged.

• Rechargeable batteries are only to be charged under adult supervision.

• Different types of batteries or new and used batteries are not to be mixed.

• Only batteries of the same or equivalent type as recommended are to be used.

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short-circuited.

• Do not dispose of the batteries in fire; batteries may leak or explode.

• Batteries should be replaced by an adult.

• When not in use for an extended time, remove batteries to prevent possible leakage.

• Use alkaline batteries for best performance.

Adults should replace batteries.

Not suitable for children under 3 years due to small parts.

NOTES

IMPORTANT

Please retain this instruction manual since it contains important information.

The preferred method of contact for Customer Service is through our e-mail contact form at www.mgae.com

0305-0

HELPFUL HINTS

Do not operate during thunderstorms.

Do not submerge your Remote Controller in water.

When your SeaSkull™ starts to lose power, it may experience loss of performance ability. If this

happens, simply replace the batteries.

Your racer is operated by radio waves. It is possible the unit may not perform properly due to

interference from nearby devices such as a cordless phone, hair dryer, radio, walkie-talkie or

other radio-controlled toys.

Avoid snow when operating your SeaSkull™.

Always select a safe place to play. Never drive your propellers in busy waterways.

Keep fingers, hair and loose clothing away from the propellors and motors while the SeaSkull™

is switched on.

1. After each use, remove any water or moisture from

SeaSkull™, by turning it upside down to drain off the water.

Afterwards, use a clean, dry cloth for cleaning.

2. Operate your SeaSkull™ only in calm, clear water. Pools

and shallow ponds are recommended. Do not operate in salt

water or sea. Do not expose SeaSkull™ to water unless the

battery compartment cover is properly closed.

3. After about 20 minutes of running time, you should pay

close attention to your SeaSkull™’s location, making sure

that it’s close to the water’s edge. That way, your

SeaSkull™ will be able to return safely under its own power.

4. Do not submerge the transmitter to water.

5. Keep fingers, hair and loose clothing away from the propeller drive while the vehicle is switched

ON.

6. To prevent entanglement, keep hair away from the propeller.

7. Do not operate near swimmers. Stand away from the water’s edge when operating.

8. To avoid accidental operation, remove all batteries when not in use.

• MODIFICATION NOT AUTHORIZED BY MANUFACTURER MAY VOID USERS AUTHORITY TO

OPERATE THIS DEVICE.

• EMISSIONS OR INTERFERENCE OF SURROUNDING ELECTRONIC EQUIPMENT MAY AFFECT

OPERATING PERFORMANCE.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

TM & © MGA Entertainment, Inc.

ALIEN RACERS

, G’ROG

, ULTROX

, GNARL

SKRASH

and all related logos, names,

characters, distinctive likenesses and slogans are

the exclusive property of MGA Entertainment.

16300 Roscoe Blvd.

Van Nuys, CA 91406 USA

(800) 222-4685

Made In China

www.alienracers.com

Quick Start

Remarks:

If your Skrash Seaskull is not running straight, please fine tune the Steering Adjuster to keep your

vehicle running straight. (Fig. 9)

BEFORE YOU START

Ages 6+

Operation manual

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5 Fig. 6

Fig. 7

Fig. 9

Fig. 8

INSTALLING BATTERIES

Transmitter (Fig. 2)

1. Driving Controls

2. Battery Door

6LR61

SKRASH SEASKULLSKRASH SEASKULL

1.5V/AA/SIZE LR6

FORWARD BACKWARD

FORWARD & LEFT FORWARD & RIGHT

OFF/ ON

INTRODUCTION

Xenoc™ is Skrash’s planet, and he’s the only one prepared to take on all of its environments.

Help him tame the waves and rule the waters with his unique, new wave-cutting SeaSkull ! This

amazingly detailed, fully-functioning R/C vehicle is fast, fun, ferocious and designed to drive on

water! At The Center of The Universe, Speed Is Power !

SeaSkull (Fig. 1)

1. Steering Adjuster (adjust, if necessary,

to keep your Seaskull running

straight.)

2. One Skrash Figure

3. ON/OFF Switch

4. Battery Door

It requires 3 x AA alkaline batteries for the Skrash Seaskull and

one 9-volt battery for the transmitter.

Powering Your Skrash SeaSkull : (Fig. 3)

1. Use a screwdriver (Philip’s head) to open the battery door.

2. Insert 3 x AA alkaline batteries with the correct polarity (+/-) as

shown inside the battery compartment.

3. Replace the battery door.

4. When you finish playing, slide the ON/OFF switch to the OFF

position.

Powering Your Transmitter: (Fig. 4)

1. Use a screwdriver (Philip’s head) to open the battery door.

2. Insert the 9-volt battery with the correct polarity (+/-) as shown

inside battery compartment.

3. Replace the battery door.

4. When you finish playing, slide the ON/OFF switch to the OFF

position.

1. Slide the ON/OFF switches on the Skrash Seaskull and transmitter to the ON position.

2. Basic operation is as shown below.