Instruction manual

48
Figure 26: Port and Point Configuration Upload
Submitting the port and point configuration may require up to 1 minute to
complete, during which time a “please wait” graphic will be displayed. Once the
upload completes, the interface will return to its normal screen. However,
clicking your browser’s refresh button may be required to reestablish
communications with the ETH-200.
This process will also result in the loss of communications with all devices
connected to the ETH-200. It is important to ensure that all connected devices
are in a safe state such that loss of communications will not pose a danger to
equipment or personnel before using this feature.
15.10 Radix Selection
Figure 27 shows the radix selection buttons. These selection buttons allow
changing the point value data display and entry radix between decimal and
hexadecimal formats.
Figure 27: Radix Selection
15.11 Editing Point Values
The value of the currently selected point can be modified using the interface
shown in Figure 28. The radix of the value entered here is determined by the
radix selection described in section 15.10. Editing the point value in this
interface and selecting “SUBMIT” immediately updates the point’s value in the
unit, which will result in a write to the point’s configured “Source Port” if one is
assigned.
Figure 28: Edit Point Value Interface