Instruction manual

OPERATION/CONTROL

3.2.4 Frequency setting

In the PU operation mode, set the frequency value used for operation performed under

the operation command given by the key ( or key).

This mode is displayed only in PU operation.

3.2.5 Parameter setting method

With the exception of some parameters, parameter setting can be made when the PU

operation mode is selected by the Pr. 79 setting.

(Also, as other to set method independently of the operation mode, you can set "2" in

Pr. 77. Refer to page 110.)

• A parameter value may either be set by updating its parameter number or setting the

value digit-by-digit using the key.

• To write the setting, change it and press the key for about 1.5 s.

Note: If parameter write cannot be performed, refer to page 176.

RUN

FWD

REV

To 3.2.5 Parameter setting mode

MODE

MODE SET REV

STOP

RESET

FWD



Frequency setting mode



Set frequency changing

SET

To frequency monitoring

MODE



Set frequency

write

Flicker

Change the set

frequency with

SET

M4500E.book 51 ページ２００５年２月２２日　火曜日　午後５時７分