User manual
22
To Perform a Control Solution Test
1. Make sure the Control Solution is at room temperature (59ºF to 95ºF or
15ºC to 35ºC) prior to testing.
2. Insert a Test Strip, white side face up with the Contact Bar’s end rst,
Push all the way into test port until meter automatically turns on. (Fig.10)
3. All segments of the LCD display will appear, a beep will sound and
moving dotted lines will appear followed by a ashing “ “ symbol. (Fig.11)
4. After the “ “ symbol appears, press the S button for 3 sec to switch
control solution mode. The “ ctl “ symbol indicates that the Meter will
mark your current test as a Control Solution test. Now you are ready to
apply the Control Solution.(Fig.12)
(Fig.11)
(Fig.12)
(Fig.10)