Technical data

ProCon HT 150 / HT 225 7. Technical documentation
7.8 Technical data RVA 47
Voltage supply
Rated voltage AC 230 V (±10 %)
Rated frequencies 50 Hz (±6 %)
Power consumption Max. 7 VA
Requirements
Protection class (for proper installation) II, according to EN60730
Protection type (for proper installation) IP 40, according to EN60529
Electromagnetic stability Conforms to EN50082-2 standards
Electromagnetic emissions Conforms to EN50081-1 standards
Climatic conditions
In operation in accordance with
IEC 721-3-3
Temperature
In storage in accordance with IEC
721-3-1
Temperature
During transportation in
accordance with IEC 721-3-2
Temperature
Class 3K5 (without condensation)
0...50°C
Class 1K3
-25...70°C
Class 2K3
-25...70°C
Dirt
In accordance with EN60730 General Environment
Me c h a n. conditions
In operation in accordance with IEC 721-3-3 Class 3M2
In storage in accordance with IEC 721-3-1 Class 1M2
IEC 721-3-2 Class 2M2
Mode of operation
In accordance with EN60730 Abs. 11.4 1b
Output relay
Voltage range AC 24...230 V
Rated flow AC 0.02...2 (2) A
Switch-on peak max . 10 A in the course of max . 1 sec
Fused connection max . 10 A
Approved lead length for PPS:
(Phone cable φ 0.8mm, 2-wire interchangeable )
Max . Lead length Central device/Peripheral device 75 m.
Max . Total lead length (Sum total of all cords) 250 m
Bus expansion Approved l ead length for L P B:
(Cu-cable 1.5 mm
2
, 2-wire not interchangeable )
With c ontrol bus feed (for each c ontroller) 250 m
With c e ntral bus feed (bus feed/controller) 460 m
Bus load factor E = 3
Approved Sensor lead
lengths
Ø 0.6 mm max . 20 m
2
1.0 mm
2
1.5 mm
max. 80 m
max . 120 m
61