Owner’s Manual Assembly and Maintenance Instructions THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY. AMCTSS AMCWSS AMCJSS AMCTMPB AMCWMPB AMCJMPB AMCTMPP AMCWMPP AMCJMPP FOR YOUR SAFETY FOR YOUR SAFETY FOR YOUR SAFETY If you smell gas: 1. Shut off gas to appliance. 2. Extinguish any open flame. 3. Open Lid. 4. Of odor continues, immediately call your gas supplier or your fire department. 1. 2.
DANGER Safety WARNINGS Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property.
Contents TABLE OF CONTENTS Safety (Dangers & Warnings)………................................................................................................…….2 Warranty……………………………………..................................................................................................4 General Instructions…………………...............................................................................................…….5 Mountings…………………………………...................................................................................
MHP AMC Series Warranty LIMITED LIFETIME WARRANTY ON THE FOLLOWING: (Against Rust Through) Cast Aluminum Top Casting & Bottom Casting • Grill Posts 10-YEAR WARRANTY ON THE FOLLOWING: (Against Rust Through) Stainless Steel Burner • 3 Piece Stainless Steel Column Base • Control Panel Stainless Steel Grill Top Insert • Stainless Steel Shelves • Stainless Steel Grids 5-YEAR WARRANTY ON THE FOLLOWING: Porcelain Briquettes • Stainless Steel Briquette Grate 1-YEAR WARRANTY ON THE FOLLOWING: (Against Rust Thr
General Instructions GENERAL INSTRUCTIONS STORAGE This installation guide provides you with easy to follow illustrations and instructions to assemble your MHP Gas Barbecue Grill. Turn gas OFF at the LP cylinder (or at the shut OFF valve in the case of Natural Gas) when the MHP Gas Barbecue Grill is not in use. Do not store spare LP cylinders under the MHP Gas Barbecue Grill.
Mounting In-Ground Post Please check to be sure that all parts are included before proceeding. Contact your dealer if any parts are missing. Keep in mind that the gas line access hole is on the back of the post and the notch at the top if facing front. Recheck plumb and allow cement to set. Parts 4' Post Post access door 28” Stainless Steel Tubing Stainless Steel Grease Cup Stainless Grease Cup Holder ¼ - 20 x ¾" Hex Head Bolts ¼ - 20 Kep Nuts 2.
Please check to be sure that all parts are included before proceeding. Contact your dealer if any parts are missing. Parts 2' Post Patio Base Post Access Door Grease Cup Holder 28” Stainless Steel Tubing Stainless Steel Grease Cup Hardware Kit ¼ - 20 x ¾" Hex Head Bolts ¼ - 20 Kep Nuts ¼" Flat Washers 8 - 32 x ½" Self Tapping Screw Tube Clip Mounting Deck/Patio Base Quantity 1 1 1 1 1 1 2.
Mounting Column/Portable Base Carton contains the following column and base components for assembly: Please check to be sure that all parts are included before proceeding. Contact your dealer or the factory if any parts are missing. Column 3 (Front, 2 Sides) Tank Locking Bar (See Pre-Pack Below) 1 Pre-Pack 12 Ft. Hose with Quick Disconnect (Natural Gas Model) 1 Base 1 Locking Casters 4 HARDWARE QUAN. Fig. A Fig.
View of Grill Head Components Mounting Grill Top Casting Thermometer Grill Head Assembly Drop-Down Side Shelf Sta-Kool Handle Grill Bottom Casting Control Panel Rotary Ignitor Left Side Burner Control Right Side Burner Control AMCW & AMCT Stainless Steel Swing Away Warming Rack AMCJ Stainless Steel Drop In Style Fig. 6 B. Connecting the Control Panel Support Brackets (Fig. 7) 1. Two support brackets are connected beneath the control panel to the grill head for added support.
Side Shelves Assembly Mounting Fold-Down Shelves Parts And Hardware: Right Brackets (2), Left Brackets (2), Shelves (2), 1/4 x 20 x 3/4 Bolts (4), 1/4 x 20 Kep Nuts (4) and 10 x 24 Nylock Nuts (2) Grill Head Assembly D. Orifice Engagement (Fig. 9) At the top end of each valve there is a tiny gas opening known as the orifice. Gas exits the orifice and enters a venturi where it mixes with air coming in from the side air shutter. The proper mixture of air and gas produces a clean blue flame at the burner.
Attaching the Grill Lid Mounting Grill Head Assembly 1. Attach the grill lid to the grill head bottom using the two Hinge Pins and Hinge Clips. (Fig. 16) Warming Rack 1. The AMCJ Warming Rack rests in the notches on the top edge of the grill head bottom. AMCJ (Fig. 19) Fig. 19 2. The AMCW and AMCT swing-away Warming Rack connects to the grill lid and the grill head bottom.
Gas & LP Tank Connections LP Gas Cylinder Requirements: (The LP-Gas Cylinder is not supplied with your MHP Grill.) The LP cylinder should be equipped with an OPD (Overflow Prevention Device) and a QCC! Or Type 1 (CGA810) cylinder connection. This cylinder connection is compatible with the grill connection. OPD is an internal mechanical device that limits the amount of liquid propane and prevents overfilling the LP cylinder.
CONNECTING THE LP CYLINDER (Fig. 19 ) Install the gas cylinder in the back of your grill, with the open side of the tank valve collar pointing towards the square hole in the tank enclosure. Ensure that all hoses, fittings and regulators are properly protected from heat and accidental damage. Hoses can be burned or chaffed if routed improperly. (See Hose and Regulator, page 3). Be sure all burner control valves on the grill are turned “OFF”.
T o Leak Testing & Lighting Lighting Your Grill ALWAYS OPEN GRILL BEFORE LIGHTING THE BURNER. Leak Testing DO NOT LEAN OVER AN OPEN GRILL. KEEP YOUR HEAD AND BODY AT LEAST ONE FOOT AWAY WHEN LIGHTING THE GRILL. LEAK TEST ALL GAS CONNECTIONS BEFORE USING YOUR GRILL. DO NOT SMOKE WHILE LEAK TESTING. IF BURNER DOES NOT LIGHT, IMMEDIATELY TURN BURNER CONTROL KNOBS TO OFF. WAIT FIVE MINUTES TO LET GAS CLEAR BEFORE YOU TRY LIGHTING AGAIN. DO NOT LEAK TEST WITH A MATCH OR OPEN FLAME.
Annual Maintenance Maintenance After a period of nonuse or to keep your grill in top operating condition, you should perform the following maintenance procedures to keep the grill ready for instant use and for your safety. Do not obstruct the flow of combustion and ventilation air. Clean inside the grill head. Remove the burner/venturi assembly and cover the valve orifices with a piece of aluminum foil to keep out dirt.
General Maintenance Maintenance Rotary Spark Ignitor System C. Check Knob, confirm quality of the electrical ground at the Rotary Ignitor. Remove the knob, loosen and retighten the mounting screws. If you experience an occasional “No-spark-No light” condition here’s a check list to troubleshoot the problem. Inspection. WITH GAS OFF, position a mirror in front of the collector box and rotate the ignitor knob several times. Observe the condition of the spark.
Cooking Techniques More Versatile than your kitchen oven...your MHP Gas Grill roasts, sears, broils, spit-roast, bakes, steams and smokes. The eating enjoyment of each cooking technique will result in a distinctive flavor for entertaining friends or a welcomed treat for a family meal. Direct—For grilling/searing steaks, chops, burgers, frankfurters, sausages, fish fillets, chicken parts or shish-ka-bobs.
Troubleshooting Problem Yellow or orange flame and the smell of gas. Cause 1. 2. 3. Blockage in the venturi tube or orifice. Orifice not seated properly in the venturi Tube. Bent or kinked hose. Check 1. 2. 3. Burner does not light or flame is low in HIGH position. 1. 2. 3. Could be a kink in the gas supply line. LP tank could be low or empty. LP regulator excess flow feature has been activated. Clean venturi (See section “Annual Maintenance”).
AMC Grill Parts Information AMCT Quantity Item Code AMCW Description Quantity Item Code AMCJ Description Quantity Item Code Description 1 GGTECL Left End Lid Casting 1 GGTC3 Left End Lid Casting 1 HHTC3 Grill Lid Casting 1 GGTECR Right End Lid Casting 1 GGTBC Bottom Grill Head Casting 1 HHBC3 Bottom Grill Head Casting 1 GGTSI Stainless Steel Lid Insert 1 GGDLB Burner 1 HHDSB Burner 1 GGTBC Bottom Grill Head Casting 67 GGBQ3R Porcelain Briquettes 53 GGBQ3R Porcelai
Outdoor Creations From MHP™ 150 South Ram Road, Antioch, Illinois 60002 Phone: 1-888-647-4745 • 847-395-6556 Fax: 1-800-637-2918 • 847-395-9121 E-Mail: customerservice@mhpgrills.com Web Site: www.mhpgrills.com MHP Grills are covered by U.S. Patent Nos. D 326,207 and D 359,877; Burners by U.S. Patent Nos.