Owner's Manual

10
Mounting
Grill Head Assembly
D. Orifice Engagement (Fig. 9)
At the top end of each valve there is a tiny gas opening known as the
orifice. Gas exits the orifice and enters a venturi where it mixes with
air coming in from the side air shutter. The proper mixture of air and
gas produces a clean blue flame at the burner.
Make sure the valve orifice on the control panel aligns with the burner
venturi tube correctly. The orifice should fit into the venturi tube ¼" to
½" inches as shown below.
WARNING! Always check the alignment of the orifice and
the venturi whenever the grill has been moved. Make sure that
the orifice fits into the venturi tube 1/4" to 1/2". Failure to
make this connection may cause fire and result in serious body
injury or damage to your grill.
Connecting the Gas Supply Line
LP Propane for portable base and deck/patio mounts:
The hose connection from the Regulator passes out the
front access opening; resting on the protected slot edge
beneath the control panel. The LP tank locking bar will
press against the tank as it is lowered into place to pre-
vent tank movement. (Fig. 10)
For Deck/Patio & In-Ground Mounts Using 30"
Flexible tubing. (Fig. 11)
Connect the 30" flexible tube to the incoming gas
supply using a 3/8" flare coupling (not supplied).
Attach the other end to the grill valve connection
behind the control panel. To tighten securely use
two wrenches. Hold valve joint with one wrench and
tighten the hose fitting with second wrench.
Tighten all gas connections securely and leak test
both ends. See Leak Testing on page 14
Burner Venturi Tubes
Front View
Side Shelves Assembly
STEP 1
MOUNTING BRACKET TO GRILL (Fig. 13 and 14)
Attach Brackets to grill using bolts and kep nuts (1 bolt per brack-
et). Tighten nuts while making sure brackets are parallel with grill.
STEP 2
ATTACHING SHELF TO BRACKET (Fig. 15)
Place the left bottom shelf post into the left bottom bracket slot.
Gently spread the shelf apart to insert the right bottom shelf post
into the right bottom bracket slot. Secure bottom posts with Nylock
Nut—making sure nuts are snug but don not restrict movement of
folding and unfolding of the shelf.
Note: Top posts on shelf do NOT use nuts.
Side View of Grill
Brackets
(Fig. 13)
MOUNTING SHELF BRACKETS TO GRILL
(Fig. 14)
Spread shelf
to insert
post
ATTACHING SHELF TO BRACKET
(Fig. 15)
OPENING SHELF
LOCK INTO PLACE
1
2
3
Bottom post
on shelf
Fold-Down Shelves Parts And Hardware: Right Brackets (2), Left
Brackets (2), Shelves (2), 1/4 x 20 x 3/4 Bolts (4), 1/4 x 20 Kep Nuts
(4) and 10 x 24 Nylock Nuts (2)
Fig. 9
Fig. 10
Fig. 12
Natural gas hose for portable base mount:
The natural gas cart uses a 12 foot hose with
a quick disconnect (supplied). The hose
passes beneath the heat shield through the
front access opening and connects directly to
the control valve. The quick disconnect end
attaches to the gas supply line at the shut-
off valve. (Fig. 12)
Fig. 11