PATRIOT SERIES Owner’s Manual Assembly and Maintenance Instructions THIS GAS APPLIANCE IS DESIGNED FOR OUTDOOR USE ONLY. FOR YOUR SAFETY Model: WCIFAB-P Propane WCIFAB-N Natural Gas If you smell gas: 1. Shut off gas to appliance. 2. Extinguish any open flame. 3. Open Lid. 4. If odor continues, immediately call your gas supplier or your fire department. FOR YOUR SAFETY Model: WCIMPB-P Propane WCIMPB-N Natural Gas Model: WCIMPP-P Propane WCIMPP-N Natural Gas 1.
Safety DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. WARNINGS Do not store a spare or disconnected liquid propane cylinder under or near the barbecue. Improper assembly may be dangerous. Please carefully follow the assembly instructions in this manual.
Contents TABLE OF CONTENTS Safety (Dangers & Warnings)………................................................................................................…….2 Warranty……………………………………..................................................................................................4 General Instructions…………………...............................................................................................…….5 Mountings…………………………………...................................................................................
MHP Patriot Series Warranty LIMITED LIFETIME WARRANTY ON THE FOLLOWING: (Against Rust Through) • Top Casting • Bottom Casting 5-YEAR WARRANTY ON THE FOLLOWING: (Against Rust Through) Stainless Steel Burner • Porcelain Briquetts • Control Panel • Column Base • Stainless Steel Shelves 1-YEAR WARRANTY ON ALL THE OTHER PARTS NOT STATED ABOVE 30-DAY WARRANTY ON PAINT WHAT IS NOT COVERED: Surface Corrosion and Discoloration • Transportation and shipping cost • Labor for replacement or repairs • Damage from
General Instructions GENERAL INSTRUCTIONS STORAGE This installation guide provides you with easy to follow illustrations and instructions to assemble your MHP Gas Barbecue Grill. Turn gas OFF at the LP cylinder (or at the shut OFF valve in the case of Natural Gas) when the MHP Gas Barbecue Grill is not in use. Do not store spare LP cylinders under the MHP Gas Barbecue Grill.
Mounting In-Ground Post Please check to be sure that all parts are included before proceeding. Contact your dealer if any parts are missing. Keep in mind that the gas line access hole is on the back of the post and the notch at the top if facing front. Recheck plumb and allow cement to set. Parts 4' Post Post access door 28” Stainless Steel Tubing Stainless Steel Grease Cup Stainless Grease Cup Holder ¼ - 20 x ¾" Hex Head Bolts ¼ - 20 Kep Nuts 2.
Please check to be sure that all parts are included before proceeding. Contact your dealer if any parts are missing. Parts 2' Post Patio Base Post Access Door Grease Cup Holder 28” Stainless Steel Tubing Stainless Steel Grease Cup Hardware Kit ¼ - 20 x ¾" Hex Head Bolts ¼ - 20 Kep Nuts ¼" Flat Washers 8 - 32 x ½" Self Tapping Screw Tube Clip Mounting Deck/Patio Base Quantity 1 1 1 1 1 1 2.
Mounting Fig. A Column/Portable Base Carton contains the following column and base components for assembly: Please check to be sure that all parts are included before proceeding. Contact your dealer or the factory if any parts are missing. Column 3 (Front, 2 Sides) Tank Locking Bar (See Pre-Pack Below) (Propane Model) 1 Pre-Pack 12 Ft. Hose with Quick Disconnect (Natural Gas Model) 1 Base 1 Locking Casters 4 Fig.
View of Grill Head Components Mounting Grill Lid Thermometer Grill Head Assembly Drop-Down Side Shelf Sta-Kool Handle Grill Bottom Control Panel Ignitor Left Side Burner Control Right Side Burner Control Nickel Plate Warming Rack Fig. 6 B. Connecting the Control Panel Support Brackets (Fig. 7) Porcelain Coated Cooking Grids 1. Two support brackets are connected beneath the control panel to the grill head for added support.
Side Shelves Assembly Mounting Fold-Down Shelves Parts And Hardware: Right Brackets (2), Left Brackets (2), Shelves (2), 1/4 x 20 x 3/4 Bolts (4), 1/4 x 20 Kep Nuts (4) and 10 x 24 Nylock Nuts (2) Grill Head Assembly D. Orifice Engagement (Fig. 9) At the top end of each valve there is a tiny gas opening known as the orifice. Gas exits the orifice and enters a venturi where it mixes with air coming in from the side air shutter. The proper mixture of air and gas produces a clean blue flame at the burner.
Attaching the Grill Lid Mounting Grill Head Assembly 1. Attach the grill lid to the grill head bottom using the two Hinge Pins and Hinge Clips. (Fig. 16) Grates, Briquettes and Cooking Grids cont. Porcelain Rock Fig. 16 Fig. 18 Connect the Handle 1. Attach the handle to the grill lid using two ¼ - 20 x 1 ½" Hex bolts with Kep nuts. Graphite Gaskets are positioned between the end caps and grill lid as shown in Fig. 17. Use two 7/16" wrenches, one to hold the bolt head and one to tighten the nut.
Gas & LP Tank Connections LP Gas Cylinder Requirements: (The LP-Gas Cylinder is not supplied with your MHP Grill.) The LP cylinder should be equipped with an OPD (Overflow Prevention Device) and a QCC! Or Type 1 (CGA810) cylinder connection. This cylinder connection is compatible with the grill connection. OPD is an internal mechanical device that limits the amount of liquid propane and prevents overfilling the LP cylinder.
CONNECTING THE LP CYLINDER (Fig. 19 ) Install the gas cylinder in the back of your grill, with the open side of the tank valve collar pointing towards the square hole in the tank enclosure. Ensure that all hoses, fittings and regulators are properly protected from heat and accidental damage. Hoses can be burned or chaffed if routed improperly. (See Hose and Regulator, page 3). Be sure all burner control valves on the grill are turned “OFF”.
T o Leak Testing & Lighting Lighting Your Grill ALWAYS OPEN GRILL BEFORE LIGHTING THE BURNER. Leak Testing DO NOT LEAN OVER AN OPEN GRILL. KEEP YOUR HEAD AND BODY AT LEAST ONE FOOT AWAY WHEN LIGHTING THE GRILL. LEAK TEST ALL GAS CONNECTIONS BEFORE USING YOUR GRILL. DO NOT SMOKE WHILE LEAK TESTING. IF BURNER DOES NOT LIGHT, IMMEDIATELY TURN BURNER CONTROL KNOBS TO OFF. WAIT FIVE MINUTES TO LET GAS CLEAR BEFORE YOU TRY LIGHTING AGAIN. DO NOT LEAK TEST WITH A MATCH OR OPEN FLAME.
Annual Maintenance Maintenance After a period of nonuse or to keep your grill in top operating condition, you should perform the following maintenance procedures to keep the grill ready for instant use and for your safety. Do not obstruct the flow of combustion and ventilation air. Clean inside the grill head. Remove the burner/venturi assembly and cover the valve orifices with a piece of aluminum foil to keep out dirt.
General Maintenance Maintenance Rotary Spark Ignitor System C. Check Knob, confirm quality of the electrical ground at the Rotary Ignitor. Remove the knob, loosen and retighten the mounting screws. If you experience an occasional “No-spark-No light” condition here’s a check list to troubleshoot the problem. Inspection. WITH GAS OFF, position a mirror in front of the collector box and rotate the ignitor knob several times. Observe the condition of the spark.
Cooking Techniques More Versatile than your kitchen oven...your MHP Gas Grill roasts, sears, broils, spit-roast, bakes, steams and smokes. The eating enjoyment of each cooking technique will result in a distinctive flavor for entertaining friends or a welcomed treat for a family meal. Direct—For grilling/searing steaks, chops, burgers, frankfurters, sausages, fish fillets, chicken parts or shish-ka-bobs.
Troubleshooting Problem Yellow or orange flame and the smell of gas. Cause 1. 2. 3. Blockage in the venturi tube or orifice. Orifice not seated properly in the venturi Tube. Bent or kinked hose. Check 1. 2. 3. Burner does not light or flame is low in HIGH position. 1. 2. 3. Could be a kink in the gas supply line. LP tank could be low or empty. LP regulator excess flow feature has been activated. Clean venturi (See section “Annual Maintenance”).
Patriot Grill Parts Information Quantity Item Code Description 1 GGTC3 Grill Lid Casting 1 GGBC3 Bottom Grill Head Casting 1 EDLB Burner 67 GGBQ3R Porcelain Briquettes 2 GGCIGRID Porcelain Cast Iron Cooking Grids 1 GGCP Control Panel 2 GGCPB Control Panel Brackets 1 GGDEF Control Panel Deflector Shield 1 GGDV13 Burner Venturi Tubes 1 GGGRATEP Briquette Grate 1 GGIB Ignitor 1 GGK9 Igintor Knob 2 GGK10 Burner Control Knobs 2 GGLPP Lid Pivot Pins 1 GGSH Sta-Kool H
Outdoor Creations From MHP™ 150 South Ram Road, Antioch, Illinois 60002 Phone: 1-888-647-4745 • 847-395-6556 Fax: 1-800-637-2918 • 847-395-9121 E-Mail: customerservice@mhpgrills.com Web Site: www.mhpgrills.com Other Quality Products From Modern Home Products The Grill That Cooks It All First in Grill Replacement Parts Everglow Stainless Steel Grills Outdoor Lighting MHP Grills are covered by U.S. Patent Nos. D 326,207 and D 359,877; Burners by U.S. Patent Nos.