Operating instructions


11
"MOJO" Series Unvented Gas Log Sets

• Turn the gas supply to the fireplace or firebox.
• Seal any fresh air vents and/or ash clean-out doors
located on the floor or wall of the fireplace. If left un-
sealed, drafting may cause pilot outage or sooting. Use
a heat resistant sealant. 



      
     

      



       
       
      
      
       
 





  
    
  



1. Center the gas log unit on the fireplace or firebox. Make
certain the front of the burner sits inside the front edge
of the fireplace or firebox.
2. Anchor holes are located on the right and left sides of
the unit. After centering the burner correctly, mark the
hole positions on the fireplace/firebox floor. Drill two (2)
5/32" diameter holes approximately 1
1
/2" deep.
3. Anchor the burner to the fireplace/firebox floor using
the screws provided. 

   

FP2006
secure to floor
Figure 13 -
Secure Heater to Floor of Fireplace/Firebox
Screw
Anchor Hole
Screw
FP2006