Operating instructions

1 65D2035
Heater in
Fireplace or
Firebox
8" or More of
Heat Resistant
Material
Hood
Measure
this
distance
Heater in
Fireplace or
Firebox
Heat
Resistant
Material

To install the heater with a wooden mantel, shelf or other combustible projection above, first measure the heat
resistant material shown in Figure 6, then see  page 13.



           

To install the gas logs into a fireplace with no wooden mantel, shelf or other combustible projection above the
fireplace opening, measure the heat resistant material height, per Figure 5, then see 
Heat resistant materials such as slate and marble must 



 If you cannot meet these minimum clearances you must operate the heater with chimney flue
damper open. See Installing Vented Applications found on page 16.






0" or more Hood not required.
8" to less than 0" Extend heat resistent material to 0" or install Hood.
See Figure 6.
Less than 8" Extend heat resistant material to at least 8" and
install hood. See Figure 6. , extend heat resistant
material to a height of at least 0".