Windsor High Efficiency Wood Stove Model WR247001 Owner’s Manual For Residential Outside Air and Mobile Home Installation in the US and Canada Safety Notice: If this appliance is not properly installed, operated and maintained, a house fire may result. To reduce the risk of fire, follow the installation instructions. Failure to follow instructions may result in property damage, bodily injury or even death.
Windsor High Efficiency Wood Stove CAUTION After reading these instructions, if you have any doubt about your ability to complete your installation in a professional like manner you should obtain the services of an installer versed in all aspects as to the correct and safe installation. Do not use temporary makeshift compromises during installation. Before Installation of Your Appliance 1. Check with the building inspector’s office for compliance with local codes; a permit may be required. 2.
Windsor High Efficiency Wood Stove Figure 2 Brick Placement Installation Contact your local buildng inspector prior to installation. A permit may be required in your area. Be sure to install two (2) full bricks (S16040) in baffle 1. Remove all parts from inside the stove body. 2. Select the proper location for the stove. These appliances must not be installed any closer than the minimum clearance to combustible materials. shown in Brick pattern (on diagram sheet).
Windsor High Efficiency Wood Stove 5. If you are connecting the stove to an old masonry flue, be sure to have it inspected for cracks and general condition. 6. It is recommended that no more than two (2) 90° bends be used in the stove pipe installation. More than two (2) 90° bends may decrease the amount of draw and possibly cause smoke spillage. 7. A damper is not required in this installation. Remove damper plate in the chimney or secure in the OPEN position.
Windsor High Efficiency Wood Stove 1. Do not install in sleeping room. 2. An outside air source is required to feed air to the firebox. 3. The stove must be securely fastened to the mobile home floor. 4. The listed chimney package, with spark arrester, must be attached directly to the stove. 5. The stove must be place on a noncombustible hearth extension pad. 6. Overall height of mobile solid fuel heater and its chimney shall not be less than 10’ (3 m) or more than 20’ (6 m).
Windsor High Efficiency Wood Stove hotter surfaces of the stove, and is caused by the heat radiating through the paint. It is also expected that shiny spots caused by friction from the packaging materials, will disappear during the curing of the stove. SO: 1. Remember to ventilate well. 2. Allow the stove to cure before burning for long periods at high temperatures. 3. Flat spots on the painted surfaces are normal. 4. Shiny spots on the paint surface before burning is normal. 5.
Windsor High Efficiency Wood Stove 7. Replace glass in door, being sure not to over-tighten screw and clip. The following steps should be followed for door gasket replacement: 1. Ensure appliance is not in operation and has thoroughly cooled. 2. Remove old door gasket and clean channel. 3. Using an approved high temperature gasket cement, apply a thin coat in bottom of channel. 4. Starting at hinge side of door, work into around door unit, and butt and trim to length. 5.
Windsor High Efficiency Wood Stove IMPORTANT Helpful Hints 1. What is the correct way to start a fire? a. You will need small pieces of dry wood (kindling) and paper. Use only newspaper or paper that has not been coated or had unknown materials glued or applied to it. Never use coated (typically advertising flyers) or colored paper. b. Open the door of the wood stove. c. Crumple several pieces of paper and place them in the center of the firebox and directly on to the firebricks of the wood stove.
Windsor High Efficiency Wood Stove and forced air furnaces compete for air resulting in inadequate amounts of air available to fuel a fire and create a condition known as negative pressure. Under extreme conditions of negative pressure the combustion by-products can be drawn from the chimney and into the house. This condition is commonly referred to as down drafting. There are several factors that impact the amount of air available in the home.
Windsor High Efficiency Wood Stove 5 2 3 1 4 7 7 8 9 7 8 10 8 15 12 11 11 11 11 12 12 12 12 12 11 11 12 11 11 12 8 MHSC reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. WR247001 Wood Stove Item No. Description Qty. Part No. 1. Door Assembly 1 S12053G 2 & 3. Glass and Gasket 1 S31117 3. 1/8” Glass Gasket 4.0’ S15001 4. 5/8” Door Gasket 4.5’ S15011 5. Spring Handle 1 90000069 6.
5 Year Warranty Windsor High Efficiency Wood Stove MHSC warrants that your new wood burning stove or masonry wood insert is free from manufacturing and material defects for a period of five years from the date of sale, subject to the following conditions and limitations. 1. This warranty is extended to the original owner only, for residential use, and is subject to proof of purchase. 2.
Windsor High Efficiency Wood Stove Po le bois Windsor haute efficacit Mod le WR247001 Pour r sidentiel de l’air ext rieur et l’installation de maisons mobiles aux tats-Unis et en Canada. AVIS DE S CURIT : Si le po le n’est pas correctement install , utilis et entretenu, il y a risque d’incendie. Pour votre s curit , veuillez suivre les directives d’installation, d’utilisation et d’entretien.
Windsor High Efficiency Wood Stove Mise En Garde Apr s avoir lu ces instructions, si vous avez des doutes quant votre capacit de faire toute l’installation d’une mani re professionnelle, vous devriez retenir les services d’un installateur qui s’y conna t relativement tous les aspects d’une installation la fois s re et correcte. NE FAITES PAS de compromis temporaires lorsque vous faites l’installation. Avant d’installer votre appareil 1.
Windsor High Efficiency Wood Stove Soufflerie Facultative : Mod le S31105 120 V, Frequ 60 Hz, 0.75 Amps 2900 RPM DANGER : Risque de secousse lectrique, d branchez avant de proc der a l’entretien. Important : Pour une meilleure performance de cet appareil au “allumage bas” le ventilateur doit fonctionner a vitesse bas. Installation 1. Retirez tous les composants plac s l’int rieur du po le. 2. Choisissez l’emplacement pour le po le.
Windsor High Efficiency Wood Stove Pi ces et outils requis pour d biller le po le et l’assembler R sidentiel • Tuyau de raccordement paroi unique ou tuyau de raccordement double paroi selon les besoins. • Vis metal #6 de 3/8 po (10 mm) pour retenir les tuyaux de raccordement. Perceuse lectrique et m ches de 1/8 po (3 mm), 5/32 o (4 mm) et de 3/16 po (4,5 mm). Tournevis pour visser les vis m tal. Maison mobile et alimnetation optionnelle en air provenant de l’ext rieur.
Windsor High Efficiency Wood Stove Chemin e Consultez les instructions du fabricant de la chemin e et des connecteurs de la chemin e. Communiquez avec les autorit s locales du b timent pour conna tre les m thodes approuv es d’installation. 1. Cet appareil doit tre raccord une chemin e en ma 610 mm (2 pi) plus lev que onnerie 1 m (3 pi) min.
Windsor High Efficiency Wood Stove Ce po le est con u pour tre utilis uniquement lorsque sa porte est ferm e. bien ventil . Et le bois doit tre gard distance de tout combustible. Mise en garde : Ce po le est con u pour ne consumer que du bois. Ne br lez pas: • du bois trait • du charbon • des solvants • des rebuts desordures • du carton • du papier color Il ne faut pas y faire br ler du charbon. Ouvrez la porte lentement pour laisser le temps aux gaz du bous de s’ chapper par la chemin e.
Windsor High Efficiency Wood Stove 5. Consultez votre marchand si vous avez des questions. Pr paration d’un feu Pour allumer ou raviver le feu, n’utilisez jamais d’essence, d’huile lampe, de k ros ne, de fluide d’allumage pour charbon de bois ou d’autres produits similaires. Gardez ces produits loin de ce po le bois. 1. Ouvrez compl tement le volet d’admission d’air. 2. Mettez quelques boules de papier sur la sole. 3.
Windsor High Efficiency Wood Stove 2. Enlevez le vieux joint et nettoyez la rainure. 3. Appliquez dans la rainure une mince couche de colle joint pour hautes temp ratures. 4. A partir du c t des chami res, ins rez le joint dans la rainure tout autour de la porte, coupez la longueur voulue et aboutez soigneusement les extr mit s. 5. Fermez la porte et laissez s cher la colle durant trois quatre heures avant d’utiliser l’appareil.
Windsor High Efficiency Wood Stove IMPORTANT Conseils qui valent la peine d’ tre r p t s 1. Quelle est la bonne mani re d’allumer un feu? a. R unissez le petit bois d’allumage et le papier. N’utilisez que des journaux ou du papier qui n’a pas t enduit ou sur lequel on a coll ou appliqu des mati res inconnues. N’utilisez jamais de paier enduit (comme les feuillets publicitaires) ou de papier de couleur. b. Ouverz la porte de votre po le bois. c.
Windsor High Efficiency Wood Stove 8. Qu’entend-on par tirage? Le tirage peut tre exprim comme tant la capacit de la chemin e vacuer les sous-produits de toule combustion normale. 9. Pourquoi a-t-on un mauvais tirage? Les facteurs les plus courants d’un mauvais tirage sont: a. La pression atmosph rique et l’allimentation en air b. Les conditions environnementales c. Une temp rature froide dans la chemin e, la pression d. Une mauvaise installation et un mauvais ntretien de la chemin e a.
Windsor High Efficiency Wood Stove 5 2 3 1 4 7 7 8 9 7 8 10 8 15 12 11 11 11 11 12 12 12 12 12 11 11 12 11 11 12 8 MHSC se r serve le droit de faire des changements en ce qui concerne la conception, les mat riaux, les sp cifications et les prix et de discontinuer des couleurs et des produits tout moment sans pr avis. Po le bois WR247001 No. Description Qt e. 1. Porte Mont e 1 2 & 3. Vitre de joint d’ tancheit 1 3. Joint de la vitre 1/8 po 4.0 pi 4. Joint de la porte 5/8 po 4.
Windsor High Efficiency Wood Stove Garantie de cinq ans MHSC garantit votre nouveau po le bois ou insert en bois et en ma onnerie contre tout d fault de fabrication et de mat rial pour une p riods de cinq ans partir de la date de vente, sous r serve des conditions et restrictions suivantes. 1. La pr sente garantie s’applique au propri taire d’origine uniquement, pour usage r sidential, sous r serve d’une preuve d’achat. 2.
MHSC 149 Cleveland Drive • Paris, Kentucky 40361 www.mhsc.