Operation Manual

Operation Manual for
Smart Hygrothermograph （Mini）
Switching temperature unit
GND
C/F
Remove the back cover when the monitor is
working normally, and use a conductive material
to connect the two contact points for about 3
seconds, and then the temperature will be
changed between °C and °F.
b.
a.
Product Overview
Front
Baery insulation sheet
Top Ventilation Holes
Rear
Adhesive Area
Cover Opening
Rear Ventilation Holes
Note:
Do not obstruct the
ventilation holes when
installing or using the
monitor.
Display
Note: Do not obstruct
the ventilation holes
when installing or
using the monitor.
Note:
Open the baery cover
and remove the baery
insulation sheet when
using the product for
the first time.
Adhesive Sticker
Placing: Directly place the monitor on the
surface of the furniture such as table,
bookshelf.
Using the adhesive sticker: Remove the
release liner from one side of the adhesive
sticker to stick it on the back of the monitor,
then remove the release liner from the other
side to stick it at the desired place on the
wall.
You can use and install your monitor in the
following ways:
Temperature
Comfort
Level Symbol
Data Transfer
Symbol
Temperature Unit
Humidity
Low Baery Symbol
Display Description
Low Baery Notification
When the baery is at a low level, the symbol
“ ”appears on the display. Please replace the
baery.
Symbol Instructions
Installation
Between 19°C
and 27°C
Between 20%
and 85%
Less than 20%
More than 85%
More than 27°CLess than 19°C
Tempe-
rature
Humidity