Safety data sheet

Page 2/8
Safety data sheet
according to 1907/2006/EC, Article 31
Printing date 26.01.2015 Revision: 26.01.2015Version 1
Trade name: mibenco LIQUID RUBBER SPRAY
(Contd. of page 1)
40.0
Signal word Danger
Hazard statements
H222-H229 Extremely flammable aerosol. Pressurised container: May burst if heated.
H315 Causes skin irritation.
Precautionary statements
P101 If medical advice is needed, have product container or label at hand.
P102 Keep out of reach of children.
P103 Read label before use.
P210 Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
P251 Pressurized container: Do not pierce or burn, even after use.
P211 Do not spray on an open flame or other ignition source.
P280 Wear protective gloves / eye protection.
P332+P313 If skin irritation occurs: Get medical advice/attention.
P403+P233 Store in a well-ventilated place. Keep container tightly closed.
Additional information:
Pressurized container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use.
Do not spray on a naked flame or any incandescent material. Keep away from sources of ignition -
No smoking.
2.3 Other hazards
Results of PBT and vPvB assessment
PBT: Not applicable.
vPvB: Not applicable.
SECTION 3: Composition/information on ingredients
3.2 Chemical characterisation: Mixtures
Description:
Mixture of substances listed below with nonhazardous additions.
Solvent naphtha: benzene content < 0,1%
Dangerous components:
CAS: 115-10-6
EINECS: 204-065-8
dimethyl ether
F+ R12
Flam. Gas 1, H220
Press. Gas C, H280
ca. 50%
CAS: 1330-20-7
EINECS: 215-535-7
xylene
Xn R20/21
Xi R38
R10
Flam. Liq. 3, H226
Acute Tox. 4, H312; Acute Tox. 4, H332; Skin Irrit. 2, H315
25 - ≤ 50%
CAS: 64742-49-0
EINECS: 265-151-9
Naphtha (petroleum), hydrotreated light
Xn R65
Asp. Tox. 1, H304
1 - 2%
CAS: 13463-67-7
EINECS: 236-675-5
titanium dioxide
substance with a Community workplace exposure limit
1 - 2%
Additional information: For the wording of the listed risk phrases refer to section 16.
SECTION 4: First aid measures
4.1 Description of first aid measures
After inhalation:
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if
symptoms persist.
In case of unconsciousness place patient in stably side position for transportation.
After skin contact:
Remove and wash contaminated clothing.
Immediately wash with water and soap and rinse thoroughly.
(Contd. on page 3)
GB