Instruction manual

6
Note:
- Installation of operator must be done by a qualified installer. Door must be properly installed and working smoothly.
Remove all door locks prior to installation.
- The PRO-J and PRO-H operators have dual output shafts and may be mounted on left (standard) or right hand side
of door. If handing of operator must be reversed, loosen set screws, remove drive sprocket and keyway and install on
opposite side of drive shaft.
For the PRO-H operator which incorporates a chain hoist mechanism the handing of the operator must be stated at
time of order. Depending on installation, if handing of chain hoist is not correct the hand chain may hang in door
opening. If this is the case, swing chain off to the side and hook it over the top of the door jamb. Do not attempt to
reverse chain hoist on site.
1. Install control station away from all moving door parts, within sight of the door and a minimum of 5 ft (1.5 m) from
the ground.
2. Install entrapment warning sign next to control station.
INSTALLATION INSTRUCTIONS
WARNING
DO NOT INSTALL THIS OPERATOR
BEFORE READING THIS MANUAL CAREFULLY.