Installation Guide

Installing your doorbell ringer
Caring for your doorbell ringer
If you have questions
The protective coating on your doorbell ringer
will last many years. You can extend the life of the
coating by occasionally applying a car wax to your
doorbell ringer.
Your doorbell ringer can be cleaned with a mild
soap and water if needed. Do not use solvents,
such as brass cleaners, as these can damage the
protective coating.
If you have any questions regarding installation
or other concerns about your doorbell ringer
please contact Michael Healy Designs directly
rather than the company from which you
purchased it. Call us at 1-800-995-0988 or email
[e-mail]. You can also
chat with us on www.michaelhealy.com.
Unique Doorbell Ringer™
Thank you for choosing a
@MichaelHealyDesigns
#AdoreMyDoor
Show us your curb appeal
View installation videos at www.michaelhealy.com/installation
1. Turn o the power to your doorbell.
2. Remove your doorbell ringer’s mounting bracket by
unscrewing the hinge screw.
3. Remove your existing doorbell and disconnect the
two wires attached to it.
4. Attach one wire to each terminal on your doorbell
ringer’s illuminated LED button. It doesn’t matter which
wire is attached to which terminal.
5. Hold the mounting bracket in place and screw it in
place using the enclosed screw. NOTE: There needs
to be a 5/8” hole for the back of the doorbell button
to recess into. In most cases the hole left by your old
button will already be 5/8”.
6. Reattach your doorbell ringer to its mounting bracket
and return power to the doorbell.