User's Manual

PRODUCT NOTICE
MICHELIN TMS-AF-01 2
PRODUCT NAME
MICHELIN TIRE MOUNTED SENSOR
PRODUCT DESCRIPTION
The MICHELIN TIRE MOUNTED SENSOR advertises, via BLE, temperature, voltage and identifier data.
Those information’s are to be received by a BLE antenna.
FCC / IC CERTIFICATION
Model : TMS-AF-01
FCC ID : FI5TMSAF01
IC : 5056A-TMSAF01
This device complies with part 15 of the FCC Rules and with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
“Le Présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit
pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.”
Changes or modifications not expressly approved by Michelin may void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instruction, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception which can be determined by turning the equipment off
and on, the user is encouraged to try to correct interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC and ISED RF radiation exposure limits set forth for general population.
This device must be installed to provide a separation distance of at least 20cm from all persons and
must not be co-located or operating in conjunction with any other antenna or transmitter.
Le présent appareil est conforme aux niveaux limites d’exigences d’exposition RF aux personnes
définies par ISDE et FCC. L’appareil doit être installé afin d’offrir une distance de séparation d’au
moins 20cm avec les personnes et ne doit pas être installé à proximité ou être utilisé en conjonction
avec une autre antenne ou un autre émetteur.