Product Info

fitment of fused signal booster (wired)

Function:

To boost the signal from the rear wheel sensors to receiver.

note: fit one booster to either side of the vehicle. 2 x boosters for

trailers and rigid chassis. None required for tractor units.

Fitting position - Rigid

The signal booster is ﬁtted as close to the rear most sensor (wheel loss or TPMS) as possible. This area will

normally be the rear most axle. You are not required to ﬁt a booster on the tractor unit.

RED Wire: connect to vehicle 12V/24V power supply directly(12~24V)

Black Wire: connect to Ground wire.

On rigid vehicles , where possible, connect to a permanent power

source so that the booster is powered when the ignition is off.

For trailer ﬁtment please wire into a positive feed and test by

connecting to a suitable tractor unit.