Product Info

20
fitment of signal booster (solar)
POSITION
OPTION 1
POSITION
OPTION 2
The solar booster should be fitted externally in an area that is close to the rear most sensors and is visible to
daylight. Because of the vast variance in trailers and rigid vehicles a degree of common sense needs to be
applied. Fit 2 x boosters, one each side of a rigid vehicle or trailer (note, boosters are not required for tractor
units) Fit in an area that is close to the rear most sensors which can be above them, in-front of or behind them.
The roof can be considered as an option. The rear of the vehicle should also be considered as an option if there
is no other obvious area available. Metallic or glass surfaces are acceptable as a fitting surface, with a none
metallic surface being preferred.
Note:
Fit one booster,
externally, to either side
OR TO THE REAR of the
vehicle.
The fitting area
should be cleaned and
free from rust/dirt/
grease.
The signal booster should be fitted as close to the rear TPMS/Wheel loss sensor as possible.