Dimensions Guide


  


1. Familiarize yourself with all of the parts before installation.
2. Turn off the water supply. Make sure both the hot and cold wa-
ter are completely shut off.
3. 
Attach the stainless steel connectors and the supply tubes to the
spount. Tighten. Screw in the threaded rod. Position the faucet rh-
gouth the sink hole with the base plate and black O-ring between
the spout and the deck top. From the underside attach the gas-
ket and mounting plate. Properly position the faucet. Tighten the
hex nut onto the mounting rod.

Mount faucet through the sink hole with base ring
between the faucet and the deck top. Place the rubber gasket
and the flat ring underneath the countertop and tighten.
Mount side spray the same as the faucet.
Connect the backflow fitting to the supply tube with the washer in
between. Connect the side spray hose to the backflow preventer
with the washer in between.
4. Connect the hot and cold water supplies. Red to hot, blue to
cold.
5. Open water supplies and check for leaks.
Remove the aerator and run both the hot and cold water to flush
out particles. Replace the aerator
Clean with water and a soft cloth. Never use cleansers. Never use any abrasives.
THIS FAUCET IS NOT TO BE CONNECTED TO PORTABLE APPLIANCE