User guide

MS-DMT Guide v1.04
Released 05-30-2014
121
commands are sent but no CAT PTT commands are sent if RS232 or EXTERNAL is
selected as the PTT TYPE.
REMOTE = The Radio requires Remote Enable and Remote Disable CAT commands, thus the radio
must be powered and properly connected to the PC before the software is started and
the software must terminate normally via EXIT for the radio to exit Remote
configuration.
RADIO MODEL
STATUS
COMMENTS
NONE
Select when RS-232 PTT is desired by not CAT commands are
desired to be sent over the port.
B2050
CAT PTT
Use for Barrett 20xx series and perhaps other models.
DATRON
CAT PTT
Use for 7000 series transceivers.
DATRON_DV
CAT PTT
Use for 7000 series transceivers for USB Data mode
operation in transmit if the option is installed in the radio
where upon return to receive USB is automatically selected
for Voice operation.
DX-SR8
CAT PTT
9600,N,8,1
Use for DX-SR8-T, DX-SR8-E, DX-SR8-J, SR9-E
NOTE: I have been informed that "Donners Country Crafts"
makes an interface for the DX-SR8 that has been tested.
Hamersville, OH 45130 Phone [phone]
http://www.donnerstore.org
Remote Control interfacing options:
1. This method is standard as used for firmware updates and
cloning. It requires an optional ERW-7(USB) or ERW-
4C(Serial) or compatible cable plugged into radio speaker