User guide

MS-DMT Guide v1.04
Released 05-30-2014
122
jack “SP” on the front panel of radio, therefore during the PC
control you must an external speaker connected to the
phone jack but the AF power is very low so a use of
commonly available PC speaker with internal amplifier.
Takes 8 to 16 ohm impedance speakers.
2. This method is more complicated and not tested. Pins 1, 2
and 6 of the 8-pin Modular RJ45 jack may possibly be used if
the control panel is separated from the radio and a Y splitter
cable is used.
1. TXD data from radio to control panel
2. RXD data from control panel to radio
3. 8V power to control panel (when radio is switched on)
4. Not in use
5. Mic signal / PWR On/Off button
6. GND
7. AF - Audio to speaker.
8. SPK GND- Speaker ground
FLEX
CAT PTT
9600,N,8,2
Supports all FLEX models, Apache Labs ANAN-10 and
possibly the Sunair RT-8100
FT817
CAT PTT
REMOTE
38400, 8N2
Also FT-650, FT-655, FT-817ND, FT-857x, FT-897x, FT-847,
VX1700 Radios must be turned on before software is started
else the radio will not respond to CAT commands.
NOTE: For FT-847 Requires the use of Null Modem cable.
NOTE: FT-650, FT-655 works at 4800 baud only. They
support 24-56Mhz coverage within our support window of
1.5-88Mhz. An external TTL level converter is required using
a 1/8 inch 3 conductor stereo plug where tip is Serial Data
Out from the PC and shield is ground is required from the
external level converter. The ring should only be connected
if the RxD line will be monitor for Squelch status for scanning
applications.
FT890
CAT PTT
This supports FT-100, FT-600, FT-747, FT-80C, FT-840, FT-