User guide

MS-DMT Guide v1.04
Released 05-30-2014
123
4800, 8N2
890, FT-900, FT920, FT-990, FT1000D, FT1000MP, SB-140,
Vertex System 600.
NOTE: FT-920 PTT works even though not documented.
NOTE: FT-990 requires ROM version 1.2 or later.
NOTE: FT-1000D requires ROM version 6.0 or later.
FT2000
CAT PTT
38400, 8N2
Also for FT-2000D, FT-450, FT-950, FTDX3000, FTDX5000,
FTDX9000
ICOM
CAT PTT
19200, 8N1
Supports any ICOM model that supports CAT PTT for use
with MIC port or on really older rigs, any port where you
need to be sure not to use a Mic wired for VOX.
NOTE: Broadcast Radio Address 00h is sent which all radios
respond to regardless of actually address.
ICOM_DV1
CAT D/V
19200, 8N1
Supports IC746PRO, IC756PRO, IC756PROII, IC756PROIII and
Signal One Milspec 1030E-DSP
NOTE: Broadcast Radio Address 00h is sent which all radios
respond to regardless of actually address.
NOTE: ACC port RX BW may be too narrow in DATA mode
for 110A and other 2400baud waveforms, but should suffice
for S4529 1200 baud requirement of 1.24Khz BW.
ICOM_DV2
CAT D/V
19200, 8N1
Supports IC7700, IC7800 DATA Mode with Wide Filter
NOTE: Broadcast Radio Address 00h is sent which all radios
respond to regardless of actually address.
IC703_DV
CAT D/V
19200, 8N1
Supports IC703
NOTE: Radio Address: 68h
IC7100_DV
CAT D/V
19200, 8N1
Supports IC7100 for DATA Mode with filter FIL1 designated
for USB port.