User guide

MS-DMT Guide v1.04
Released 05-30-2014
125
respond to regardless of actually address.
JSB176
CAT PTT
REMOTE
1200, 8N1
Also supports Raytheon RAY 152 and possibly RAY 150.
NOTE: Optional RS232C unit CMM-741 must be installed
piggyback on the CPU Unit CDC-493R. The radio must be in
RMT via the front panel. A straight RS-232 cable is required.
JSB196
CAT PTT
REMOTE
9600,7E1
JRC JSB-196 and JSB-196GM Marine SSB radios using
firmware older than v1.7 that requires data string checksum
support.
NOTE: Null modem cable required.
JST245
CAT PTT
REMOTE
4800, 8N1
Also select for JST-145 and JST-135 operation.
NOTE: For JST-135 1200 baud must be selected.
K3_DV
CAT D/V
38400, 8N1
Supports K3 data port for PTT where the radio is switched
into DATA mode for TX and to USB on RX for Voice comms.
For basic K3 CAT PTT use selection KNWD450.
K3 directly supports RS232 RTS line for PTT if enabled.
KNWD450
CAT PTT
4800, 8N2
Sends TX; for PTT ON and RX; for PTT OFF, supports
Kenwood legacy radio models and many other
manufacturers models that have adopted the Kenwood
command protocol.
NOTE: Use this selection for older firmware TS-2000
KNWD480
CAT PTT
9600, 8N2
Sends TX1; for PTT ON and RX; for PTT OFF in support of 480
ANI port and 590 USB port.
KNWD590
CAT PTT
9600, 8N2
Sends TX0; for PTT ON and RX; for PTT OFF in support of TS-
590
NOTE: Use this selection for newer firmware TS-2000