User guide

MS-DMT Guide v1.04
Released 05-30-2014
90
“Send” - Sends the message located in the “Outgoing Message Window” if any message is
present. The “Send” and “Send HL” buttons and other selections are disabled during
transmitting as seen in the screen capture at the end of this section. The EXIT button is active
during transmitting should the transmission require termination.
“Send HL” - Supports resending any part of a multi-line message in the Outgoing Message
Window where for whatever reason, it is desired to only send part of the message. The user
must highlight that portion of the message of interest as if to copy, once highlighted, clicking on
"Send HL" instead of "Send" will transmit the highlighted part of the message as seen below.
“Send File” - Supports the selection of an ASCII file to send its contents as the message or to
view its contents in the “Outgoing Message Window” when “View File” is checked, for more
details see Appendix B herein.
“Clear” - Clears the Outgoing Message Window and resets the scroll bars.
“Kill” - This button will only be displayed when the tool is in transmit and clicking it will stop the
current transmission and clear all transmit buffers.
NOTE: Kill button is currently disabled while still under going further development.
“Repeat” - When clicked the last keyboard message sent during the current session will be
pasted back to the keyboard message window for editing or immediate resending.