Hydromatic II Chiller Operation Manual
Table Of Contents
- Introduction
- Getting Started
- System Overview
- Operational Overview
- Initial Configuration
- System Menu Items
- Operation
- Fault Handling
- Wiring Diagrams
- Specifications
- Glossary
- Appendix 1: System menu overview
- Appendix 2: Organizing IDs in the CAN system
- Appendix 3: Ordering a system
Page 13
Rev 1.07 ©2015 Micro Air Corp 10/26/2015
Heater on slave N
N is replaced by the unit ID of the control being changed. If the number of slaves is set
for 4 and the group ID is 131, you will see menu items for heater on slaves 131 to 134.
This parameter allows the user to program which stage an electric heater is installed on.
Select “YES” for that slave if an electric heater is connected to the slave or “NO”, if the
slave does not have an electric heater connected.
Enable slave N
N is replaced by the unit ID of the control being changed. If the number of slaves is set
for 4 and the group ID is 131, you will see menu items for enable slave 131 to 134.
Select “Yes” to enable the slave or “No” to disable the slave.
Slaves on stage X
The value for this parameter indicates how many compressors or heaters will be turned
on for each temperature change set by differential or off for each temperature change set
by hysteresis.
Pump ID
This parameter selects the serial number of the control board used for the system pump.
Pressing the button scrolls through the available choices. Any pump control board
on the system may be selected as the system pump. Be sure to select the correct pump
control board for the system being configured.