Hydromatic II Chiller Operation Manual
Table Of Contents
- Introduction
- Getting Started
- System Overview
- Operational Overview
- Initial Configuration
- System Menu Items
- Operation
- Fault Handling
- Wiring Diagrams
- Specifications
- Glossary
- Appendix 1: System menu overview
- Appendix 2: Organizing IDs in the CAN system
- Appendix 3: Ordering a system
Page 15
Rev 1.07 ©2015 Micro Air Corp 10/26/2015
Slave Overview
Slave Overview
The slave overview will be shown when you are viewing is
not configured as a master. This view is also available on the
master in the diagnostic view. If the return sensor is installed,
the tempered water return temperature for the slave is
displayed on the top left. The tempered water outlet
temperature for the slave is displayed on the top right. CW is
the system tempered water loop, SW is the system sea water
loop and the piston symbol in the center is for the slave’s
compressor. System sea water temperature is indicated under “SEA” in the center of the
screen. Sea water temperature is only valid while the sea water pump is running.
Pump Control Board
The loop water pump and sea water pump operation is automatically controlled by the
master. LED indicators on the board illuminate when a pump is on. The Flow 1 LED will
light whenever the loop water switch is closed. The Flow 2 LED will light whenever the
sea water flow switch is closed.