Hydromatic II Chiller Operation Manual

Page 29
Rev 1.07 ©2015 Micro Air Corp 10/26/2015
Appendix 1: System menu overview
Diagnostic view
View 1 (See manual)
View 2 (See manual)
Slave View (Master only)
Show event history
Events 1-8
Copy unit in system (Items in red available only when system is off)
Copy slave
Operating parameters
Purge air
Staging delay
Heat mode set point
Cool mode set point
Hysteresis
Differential
Electric only temperature
Sea pump operation
Low voltage shut down
Back to menu
System set up
Brightness
Screen saver brightness
Service high limit
Current limit
Freon sensor type
High pressure maximum PSI (Both or gauge only)
High pressure 0 PSI voltage (Both or gauge only)
Low pressure maximum PSI (Both or gauge only)
Low pressure 0 PSI voltage (Both or gauge only)
Water sensor type
LPS pressure maximum PSI (Both or gauge only)
LPS pressure 0 PSI voltage (Both or gauge only)
HPS pressure maximum PSI (Both or gauge only)
HPS pressure 0 PSI voltage (Both or gauge only)
System units
Reset parameters
Back to menu
Staging parameters
Group ID
Unit ID
Number of slaves
Heater on slave (1-8)
Enable slave (1-8)
Slaves on stage (1-8)
Pump ID
Back to menu