ECU MAXX to FX-2 EasyStart Conversion Manual Micro Air Corporation 124 Route 526. Allentown NJ 08501 Phone (609) 259-2636 WWW.Microair.
Introduction The FX-2 control board with EasyStart and a compatible display can be used to replace the ECU-Maxx control board. Compressor starting currents with EasyStart will be significantly reduced from the original ECU Maxx control board. Follow the steps outlined in this manual to install the FX-2 control board.
4. Connect the Sensors Use the lower diagram on the Sensor Changes page to complete the sensor wiring. Connect the wires from 15 to 17, labeled in step 1, to the appropriate numbered terminal in as shown in the lower diagram. Note that one wire from each pressure switch will be connected together and connected to the middle wire on the connector. 5.
AC Wiring Changes Revision: 1.03 ©2019 Micro-Air Corp.
Sensor Changes Revision: 1.03 ©2019 Micro-Air Corp.
COPYRIGHT © 2017 Micro Air Corporation, All Rights Reserved No part of this publication may be reproduced, translated, stored in a retrieval system, or transmitted in any form or by any means electronic, mechanical, photocopying, recording or otherwise without prior written consent by Micro Air Corporation. Every precaution has been taken in the preparation of this manual to insure its accuracy. However, Micro Air Corporation assumes no responsibility for errors and omissions.