AirNet CAN to Ethernet Adapter Setup Manual Micro Air Corporation 124 Route 526 Allentown NJ 08501 Phone (609) 259-2636 www.Microair.
Note to installers: These manual requires making changes to the network router and obtaining a DDNS service. Understanding this manual and the user manual for the router used are required to successfully install this device. Please read and understand all sections of this manual before proceeding with installation. Making the wired connections: 1. Install all controls and associated hardware per manufacturers guidelines. 2.
5. Plug in the Ethernet cable from the router to the AirNet CAN to Ethernet adapter. 6. Power all the controls in the system but do not power the AirNet CAN to Ethernet adapter until all the controls have been powered. If you powered the adapter first, simply remove power for 10 seconds, and then reapply power. Wiring FAQ Power was applied before the wiring was completed. What do I do? The first time the network is powered, the AirNet CAN to Ethernet adapter collects information about the system.
Configure the AirNet CAN to Ethernet adapter: Finding the AirNet CAN to Ethernet adapter on the network: To configure the adapter, you will need to determine the network address for the adapter. Find the MAC address printed on the AirNet Can to Ethernet adapter case. Log into your router and browse to the DHCP client table (consult your routers documentation to determine how to access the DHCP table).
Change your admin password: Your admin password can be changed so no users may make changes to your settings. To change the password, press “Change Admin Password” then enter a new password (up to 20 characters) in the text window at the top and press “Save”. Be sure to remove the word “Password” from the text box. It is only there as a prompt.
Setting up your router for internet access: The following instructions are used when an internet connection to the router is available. These steps permit the iPhone™ AirNet5i application to control the supported devices from anywhere. The adapter must be configured before completing these steps. See “Configuring the adapter” for details. Step 1: Set up a router or PC with a DDNS service.
What address do I enter in the iPhone application? If you chose, for example, a noip.com address of MyWonderfulYacht.noip.me as your DDNS address and you selected port 12345 as your port, you would enter MyWonderfulYacht.noip.me:12345 as the global address in the iPhone™ AirNet 5i application. The app will automatically connect to the appropriate address when the app is started. ©2015 Microair Corp 7 Rev: 1.
Organizing IDs in the CAN system Controls are addressed on the CAN bus by assigning group ID and unit ID numbers to each control in the system.
Reset connection settings: Two small holes by the Ethernet connection provide access to the reset switches. Resetting the DHCP and static address: The switch closest to the CAN connector enables the DHCP server and clears the static IP setting. This is useful if you move the adapter to a new router with a different net address. Press and hold this switch for at least 10 seconds to reset the server to the factory connection settings.
