EasyTouch WIFI iPhone™ and Android™ Application Operating Manual Micro-Air Corporation Contact us at: www.Microair.net www.Micro-air.com Help@Microair.
Table of Contents EasyStart WIFI Application: ....................................................................................................................... 2 Connecting EasyTouch to your Router: ...................................................................................................... 2 Program Start:.............................................................................................................................................. 4 Selecting an EasyTouch: ...................
. Press the down button (see figure 3) then press “System Menu”. Figure 3 4. Press the down arrow again, then press “WI-FI SETTINGS” (See figure 4). Figure 4 5. Press “NETWORK NAME” (See figure 5) Figure 5 6. You will need to know your routers SSID name and password for the next steps. The SSID name is the same name used when a phone or tablet is selected from the devices WIFI control panel. Use the DEL key to remove the default name. Use the up and down buttons to change the letter in the name.
Program Start: Android and iPhone applications will search for local controls whenever the application is started. 1. Android: A search bar will appear at the top of the screen and at the conclusion of the search the select location screen will appear. The search may be skipped when connecting to controls not connected to the local network by pressing “Skip Search” at the top of the screen. Apple Android 2.
Controlling EasyTouch: Once the desired control is selected, simply select the desired fan speed mode and set point. Additional system details can be viewed by pressing the detail button. This view shows additional sensors, optional boards like EasyStart, humidity control, and output status. Accessing EasyTouch outside the local network: Accessing EasyTouch from outside the local network requires setting up a DDNS service and changes to your router.
If a service is used that your router does not support, you will need a DDNS client installed on a PC or network device that runs all the time. The client is just a PC program that you run and setup just like the setup in the router. Step 2: Enable port forwarding in your router to one EasyTouch IP address. Follow your routers setup instructions to forward an external port (over 1024 for most ISP’s) to the IP address of the EasyTouch you selected and use port 80 as the port to forward to.
