Specifications
Table Of Contents
- Content
- Welcome!
- Warranty
- 1. Getting Started
- 2. Software Configuration
- 3. Data Capturing
- 3.1. Open Files
- 3.2. Replay of Files
- 3.3. Editing Video Sequences
- 3.4. Saving Files
- 3.4.1. Setting the Recording Frame Rate
- 3.4.2. Setting the Recording Modes
- 3.4.3. Temporary Recording File
- 3.4.4. Saving Radiometric Video Sequences or AVI Files
- 3.4.5. Saving Image Data as Radiometric Snapshot or Text File
- 3.4.6. Saving Text File of the Temperature / Time Diagram
- 3.4.7. Location and Filename Templates of Triggered Recordings
- 3.4.8. Display of Snapshots in a Separate Window
- 3.4.9. Saving Images or Screenshots to Clipboard
- 4. Data Processing
- 5. Visual Camera (TIM200 only)
- Linescanner Mode
- 7. Further Information
thermoIMAGER TIM 31
The process interface has an integrated failsafe mode. This allows to control conditions like interruption of
cables, shut-down of the software etc. and to give out these conditions as an alarm.
Controlled conditions on camera and software
Standard Process interface
TM-PIF-TIM
Industrial Process interface
TM-PIF500V-TIM
Interruption USB cable to camera √ √
Interruption data cable camera - PIF √ √
Interruption power supply PIF √ √
Shut-down of TIMConnect software √ √
Crash of TIMConnect Software
1)
- √
Failsafe output 0 V at analog output (AO) Open contact (alarm relay)
1)
It is possible that some malfunctions of the software under certain circumstances cannot be detected. Therefore a 100%
software crash control cannot be guaranteed.
The failsafe function can be activated in the Analog Output
settings. The checkbox Stop fail-safe pulse on alarm must be
activated, if the analog output should be used in addition as an
alarm output for a temperature alarm. In case of an alarm the
alternating fail-safe pulse signal will stop and the set voltage
level will be given out as constant value. (Industrial PIF only)