Specifications
Table Of Contents
- Content
- Welcome!
- Warranty
- 1. Getting Started
- 2. Software Configuration
- 3. Data Capturing
- 3.1. Open Files
- 3.2. Replay of Files
- 3.3. Editing Video Sequences
- 3.4. Saving Files
- 3.4.1. Setting the Recording Frame Rate
- 3.4.2. Setting the Recording Modes
- 3.4.3. Temporary Recording File
- 3.4.4. Saving Radiometric Video Sequences or AVI Files
- 3.4.5. Saving Image Data as Radiometric Snapshot or Text File
- 3.4.6. Saving Text File of the Temperature / Time Diagram
- 3.4.7. Location and Filename Templates of Triggered Recordings
- 3.4.8. Display of Snapshots in a Separate Window
- 3.4.9. Saving Images or Screenshots to Clipboard
- 4. Data Processing
- 5. Visual Camera (TIM200 only)
- Linescanner Mode
- 7. Further Information
thermoIMAGER TIM 77
If activated Avoid re-triggering during scan will not allow to run a new linescan
cycle while a previous cycle trigger by recent signal is not finished.
Note
For external triggering it is necessary to do modifications of the standard configuration on the Process
Interface (PIF). You will find more details in the chapter 2.5.
Using the Self triggered option it is possible to use a triggering signal provided by software to control arranging
of the scanned lines. Number of lines being reloaded after this signal is defined under Lines und History [sec]
(see 6.3.1). Further
modifica
tions can be carried out:
First of all Trigger area within the infrared image needs to be specified.
In Left, Right, Top and Bottom position of particular corner needs to
be selected. Switch to Linescanner sighting view mode to see the
visualization of the triggered area for your reference.
