User`s manual

2-6
MS-9625 M-ATX Workstation Board
Memory
Installing DDR Modules
1. The DDR DIMM has only one notch on the center of module. The module will only fit
in the right orientation.
2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the
golden finger on the memory module is deeply inserted in the socket.
3. The plastic clip at each side of the DIMM slot will automatically close.
The mainboard supports up to 2GB of DDR333 (two 184-pin 333MHz non-ECC DDR
DIMMs) or DDR-II 400/533 (two 240-pin 400/533MHz non-ECC DDR-II DIMMs) system
memory. Please note that only one type of memory (all DDR or all DDR-II, no mixture
allowed) can be used at one time.
For more information on compatible components, please visit http://www.msi.com.
tw/program/products/server/svr/pro_svr_qvl.php .
MSI Reminds You...
You can barely see the golden finger if the module is properly inserted
in the socket.
Volt
Notch
DIMM4 (DDR-II 400/533)
DIMM3 (DDR-II 400/533)
DIMM2 (DDR333)
DIMM1 (DDR333)