User`s manual

B-14
MS-9625 M-ATX Workstation Board
RAID Migration Instructions
The Intel Application Accelerator RAID Edition offers the flexibility to upgrade from a
single Serial ATA (SATA) hard drive to a two drive RAID 0 or RAID 1 configuration
when an additional SATA hard drive is added to the system. This process will create
a new RAID volume from an existing disk. However, several important steps must be
followed at the time the system is first configured in order to take advantage of RAID
when upgrading to a second SATA hard drive:
1. BIOS must be configured for RAID before installing Windows* XP on the
single SATA hard drive. Refer to OnChip SATA Setting for properly
setting of the BIOS.
2. Install the Intel Application Accelerator RAID Driver during Windows Setup.
Refer to P.5-8 Installing Software for instructions on installing the
driver during Windows Setup.
3. Install the Intel Application Accelerator RAID Edition after the operating
system is installed.
To create a volume from an existing disk, complete the following steps:
After the Intel Application Accelerator RAID Edition has been successfully installed
and the system has rebooted, click on the Intel Application Accelerator shortcut link
(Start --> All Programs --> Intel(R) Application Accelerator --> Intel Applica-
tion Accelerator) and the following window will appear:
MSI Reminds You...
A Create from Existing Disk operation will delete all existing data
from the added disk and the data cannot be recovered. It is critical to
backup all important data on the added disk before proceeding. However,
during the migration process, the data on the source disk is preserved.
9625v1.0-Appendix B(ICH6R SATA RAID).p65 2005/8/4, 下午 02:4314