User`s manual

BD-121
13
Screen Saver
Use this setting to enable or disable the Screen Saver feature. When this is enabled, a screen
saver is displayed whenever your duplicator has been idle for a set period of time.
Duplication Mode
This setting cannot be changed.
Counter
Use the Counter menu to enable or disable the Counter feature. The counter tells you how many
discs have copied and how many discs are left to go during the duplication process stopping the
job once the desired number of copies has been made.
DVD+R High Compatibility Mode
This feature allows you to turn the DVD+R High Compatibility Mode feature ON or OFF. The
purpose of this feature is to increase the compatibility of DVD+R media with a broader range of
DVD Video players.
ISRC
This option will allow you to enable/disable copying the ISRC code of an Audio CD. ISRC is the
serial number of the audio track that uniquely identifies the song in that audio track. This ISRC
code is commonly found in commercial Audio CDs and rarely seen on home made Audio CDs. By
enabling this feature, the duplication performance will be lowered.
Disable Drives
This utility allows you to disable specific drives when they are producing high failure rates. Note
that if one drive is disabled, however, the BD-121 will no longer have enough drives available to
duplicate from your master to a blank disc. This function should not be used.
External Connection
Use this setting to enable the bottom recorder drive to be used as an external drive connected to
your PC via a USB 2.0 connection. Please note that while this setting is ON, the BD-121 cannot
be used as a duplicator, as no target drive will be available.
To connect the bottom drive to your PC, you will need to connect your PC and the
duplicator using the supplied USB cable. Plug the flat end of the USB cable to your
PC and the square end to the connection on the back of the duplicator, shown to
the right.
Select the Setup menu and use the ▼▲ buttons and press the ENT button the display reads
External Connection. If the display indicates that the connection is OFF, use either arrow key to
change the setting to ON, then press ENT to save the setting. The duplicator will be briefly
unresponsive as the bottom drive is released from duplication mode. Press ESC to leave the
Setup menu.
To shut off the External Connection, simply change the External Connection setting to OFF. This
setting can be changed any time both the tower and bottom drive are idle, but you may need to
remove any media from the bottom drive before the drive will be recognized again. You do not
need to disconnect the USB cable.
CD+G Support
Due to BluRay drive limitations, this feature is not supported on the BD-121, and the setting
should remain OFF.