Specifications

MICROBOARDS TECHNOLOGY, LLC G3 AUTO PRINTER

Installing Ink Cartridges

Supported Ink Cartridges

The G3 Auto Printer uses a single color ink cartridge. The part number for this cartridge is GX-

300HC. If other cartridges are installed, the G3 Auto Printer will not function. These cartridges are

available from any Microboards reseller.

Refill kits or non-Microboards ink cartridges are not recommended for use in the G3 Auto

Printer system. Use of these types of cartridges will cause the printer to fail. Use of these

types of cartridges will void the warranty.

Loading / Replacing Ink Cartridges

Cartridges should be changed while the G3 Auto Printer is on. The cartridge can be replaced during

printing.

The G3 Auto Printer system ships with one Microboards GX-300HC color ink cartridge.

• Lift the front cover with the power on. The print cartridge cradle will move to the right side of

the G3 Auto Printer, as shown below.

• Tilt the old cartridge forward to release the cartridge from the cradle, as shown in the inset

below.

• Lift the old cartridge out of the cradle.

• Remove the new GX-300HC ink cartridge from its packaging and carefully remove the plastic

tape. Hold the ink cartridge so that the copper strip is at the bottom.

• With the front of the new GX-300HC ink cartridge tilted down, slide the cartridge into the

cradle.

• Tilt the front of the GX-300HC ink cartridge back up to lock the ink cartridge in place.

• Lower the front cover.

• The new GX-300HC ink

cartridge will be initialized

by the printer.

The Microboards GX-300HC

Ink Cartridge must be used

or the printer will not

function.